cement plaster (stucco) wall claddings as specified by ASTM stucco industry standards. Standards ASTM C and ASTM C were carefully researched by. Lathing and furring accessory and fastener installation requirements remain in C as well. This standard does not replace ASTM C violation of the building code IBC and FBC referenced ASTM. C, which establishes the requirements for stucco applied over a metal plaster base a.k.a. lath.
|Country:||Trinidad & Tobago|
|Published (Last):||2 March 2016|
|PDF File Size:||18.86 Mb|
|ePub File Size:||4.45 Mb|
|Price:||Free* [*Free Regsitration Required]|
With a copyright, the document is not to be duplicated without ASTM permission.
WallsandCeilings – September 2018
The standard is listed under C Since its formation inthe ASTM C11 Stucco Work Group has worked toward reconciling inconsistencies in current standards and creating new standards that reinforce consistency in the stucco industry.
Link to Active This link will always route to the current Active version of the standard. ASTM does not give any warranty express or implied or make any representation that the xstm of this abstract are accurate, complete or up to date. Little is senior product manager at ClarkDietrich Building Systems.
A New ASTM For Plaster Accessories
This specification covers the installation of lathing and furring to receive interior and exterior Portland cement-based plaster. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
This specification c10063 the minimum requirements for lathing and furring accessories, fasteners, etc.
Hangers and cold-rolled channel main runner shall conform to the allowable x1063 and spans, respectively. This page can be found at http: This abstract is a brief summary of the referenced standard.
Historical Version s – view previous versions of standard. These requirements do not by default define a unit of work or assign responsibility for contractual purposes, which is the purview of a contract f1063 contracts made between contracting entities.
He has 20 years of experience in new product development and technical support, and has also played an integral role in helping shape industry standards for lathing and plastering, as well as installation of masonry stone veneer.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Looking forward, the SWG is now developing requirements that will fill the significant needs of building owners, designers, and craftsmen in the stucco industry for the use of continuous insulation and drainage, addressing other important stucco industry topics.
The new standard is available and ready at astm. Work Item s – proposed revisions of this standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
These were included to provide basic guidance on the shape or appearance of the accessories; both old and new. Little can be reached at c.
The following materials shall be used: This new standard will be useful to a wide spectrum of stakeholders, including building owners, specifiers, engineers, architects, manufacturers, and applicators throughout the industry. The Stucco Work Group meets virtually via webinar and review items that have been proposed, make suggested changes and then develop those into ballot-worthy items for the ASTM committee to vote on a semi-annual basis.
Lathing and furring accessory and fastener installation requirements remain in C as well. The following methods are discussed: